DTC Advanced Diagnostics: P0462
DTC P0462:Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Low Voltage (Engine Type: K24W1)

General Description

The fuel level sensor (fuel gauge sending unit) is incorporated into the fuel pump and installed in the fuel tank. Using a built-in potentiometer and float, it converts the movement of the float to electrical signals as an output that corresponds fuel level variations in the fuel tank. The fuel level, which is indicated by the gauge control module, is sent to the powertrain control module (PCM) via the controller area network (CAN). If the PCM detects a signal from the fuel level sensor (fuel gauge sending unit) below a predetermined value for a set time, it detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type, OBD Status
Execution
Continuous
Sequence
None
Duration
5 seconds or more
DTC Type
Two drive cycles, MIL off
OBD Status
PASSED/FAILED/NOT COMPLETED (STILL TESTING)

Enable Conditions
Condition
Minimum
Maximum
Battery voltage [BATTERY]
10.0 V
–
Ignition switch*1
ON (II)
Engine start/stop button*2
ON mode
No active DTCs set (prevents monitor from running)
P0463, U0029, U0155
*1: Without keyless access system

*2: With keyless access system

[ ]: HDS Parameter

Malfunction Threshold
The fuel level sensor (fuel gauge sending unit) output voltage is 0.10 V or less for at least 5 seconds.

Possible Cause
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
Fuel level sensor (fuel gauge sending unit) FUEL GAGE+ line short to ground
Fuel level sensor (fuel gauge sending unit) failure
Gauge control module internal circuit failure
PCM internal circuit failure

Diagnosis Details
Conditions for setting the DTC
When a malfunction is detected during the first drive cycle, a Pending DTC is stored in the PCM memory. If the malfunction returns in the next (second) drive cycle, a Confirmed DTC and the freeze data are stored. The MIL does not come on.

Conditions for clearing the DTC
The Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the battery.