DTC Advanced Diagnostics: P0685 (V6) - Honda Accord CR/CT 2012-2017

DTC Advanced Diagnostics: P0685

DTC P0685:Powertrain Control Module (PCM) Power Control Circuit/Internal Circuit Malfunction (Engine Type: J35Y1, J35Y2)

General Description

After the engine start/stop button is pressed to select the OFF mode, the powertrain control module (PCM) does not shut down immediately. After finishing a predetermined process according to the request of each device and system, the power supply is automatically disconnected (self shut-down function). The PCM power is disconnected by controlling PGM-FI main relay 1. During a normal PCM shut down, the shut down process is executed by the CPU, PGM-FI main relay 1 is turned off, and the voltage to the PCM is turned off to shut down the PCM. When the voltage to the PCM is turned off and the PCM shuts down without the normal shut down procedure, the PCM detects a malfunction in the PGM-FI main relay 1 control circuit and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type, OBD Status

Execution	Continuous
Sequence	None
Duration	1 second or less
DTC Type	Two drive cycles, MIL on
OBD Status	PASSED/FAILED/NOT COMPLETED (STILL TESTING)

Enable Conditions

Condition	Minimum	Maximum
Elapsed time after starting the engine	10 seconds	–
Engine speed [ENGINE SPEED]	400 rpm	–

[ ]: HDS Parameter

Malfunction Threshold

The PCM is shut down within 1 second without the normal shut down procedure.

Possible Cause

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.

	PCM internal circuit failure
	PGM-FI main relay 1 FI MAIN RLY CL- line intermittent open
	PGM-FI main relay 1 failure
	PGM-FI main fuse failure
	Poor connections or loose terminals between PCM and under-hood fuse/relay box
	Poor or loose PCM ground terminals and connections
	Poor or loose battery cables and connections
	Battery failure

Diagnosis Details

Conditions for setting the DTC

When a malfunction is detected during the first drive cycle, a Pending DTC is stored in the PCM memory. If the malfunction returns in the next (second) drive cycle, the MIL comes on and a Confirmed DTC and the freeze data are stored.

Conditions for clearing the DTC

The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the battery.