DTC Advanced Diagnostics: P0351, P0352, P0353, P0354
DTC P0351:No. 1 Cylinder Ignition Coil Circuit Malfunction (Engine Type: K24W1)
DTC P0352:No. 2 Cylinder Ignition Coil Circuit Malfunction (Engine Type: K24W1)
DTC P0353:No. 3 Cylinder Ignition Coil Circuit Malfunction (Engine Type: K24W1)
DTC P0354:No. 4 Cylinder Ignition Coil Circuit Malfunction (Engine Type: K24W1)

General Description

The ignition coil is triggered at the optimum time by the powertrain control module (PCM) ON/OFF command. The PCM detects a malfunction when the engine is running and the return signal does not change for a specified time, the PCM detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type, OBD Status
Execution
Continuous
Sequence
None
Duration
5 seconds or more (when the engine speed is 700 rpm)
DTC Type
One drive cycle, MIL on
OBD Status
PASSED/FAILED/NOT COMPLETED (STILL TESTING)

Enable Conditions
Condition
 
State of the engine
Running
No active DTCs set (prevents monitor from running)
P0335, P0339, P0365, P0369

Malfunction Threshold
The return signal does not change for at least 5 seconds when the ignition coil is triggered.

Possible Cause
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
P0351
No. 1 ignition coil IGNO1 line open
No. 1 ignition coil IGNO1 line short to ground

P0352
No. 2 ignition coil IGNO2 line open
No. 2 ignition coil IGNO2 line short to ground

P0353
No. 3 ignition coil IGNO3 line open
No. 3 ignition coil IGNO3 line short to ground

P0354
No. 4 ignition coil IGNO4 line open
No. 4 ignition coil IGNO4 line short to ground

Common
Ignition coil power supply line open
Ignition coil ground line open
Ignition coil internal circuit failure
PCM internal circuit failure

Diagnosis Details
Conditions for setting the DTC
When a malfunction is detected, the MIL comes on and a Pending DTC, a Confirmed DTC, and the freeze data are stored in the PCM memory.

Conditions for clearing the DTC
The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the battery.