Cylinder Head Inspection for Warpage
1.
Cylinder Head - Remove
Remove the cylinder head
.
2.
Camshaft - Inspect
Inspect the camshaft
.
3.
Cylinder Head Warpage - Inspect
Check the cylinder head for warpage. Measure along the edges, and three ways across the center:
If warpage is less than 0.05 mm (0.002 in) cylinder head resurfacing is not required.
Maximum resurface limited to the cylinder head height standard as shown.
Cylinder Head Warpage
Standard (New):
0.05 mm (0.002 in) max.
Cylinder Head Height
Standard (New):
111.95?112.05 mm (4.4075?4.4114 in)
4.
Cylinder Head - Install
Install the cylinder head
.
