Rocker Arm Oil Pressure Sensor Removal and Installation
1.
Rocker Arm Oil Pressure Sensor - Remove
1.
Disconnect the rocker arm oil pressure sensor connector (A).
2.
Remove the rocker arm oil pressure sensor (B).
3.
Remove any old liquid gasket from the switch and the switch mounting hole.
1.
Rocker Arm Oil Pressure Sensor - Install
1.
Apply liquid gasket (/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the rocker arm oil pressure sensor threads. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
Using too much liquid gasket may cause liquid gasket to enter the oil passage or the end of the rocker arm oil pressure sensor.
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
2.
Install the rocker arm oil pressure sensor (A) with a new O-ring (B).
3.
Connect the rocker arm oil pressure sensor connector (C).
