Steering Angle Sensor Neutral Position Clear

NOTE: The steering angle sensor neutral position must be cleared whenever the steering joint, the steering wheel, or the steering angle sensor is removed or if the front toe is adjusted.

1. HDS DLC - Connect
1.
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
3.
Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

2. Steering Angle Sensor Neutral Position - Clear

Select EPS ADJUSTMENT, then select EPS STEERING ANGLE SENSOR VALUE CLEAR and follow the screen prompts on the HDS.

NOTE: See the HDS Help menu for specific instructions.