Remove the self-locking nut (A) and the flange nut (B) while holding the respective joint pin (C) with a hex wrench (D).
2.
Remove the stabilizer link (E).
1.
Stabilizer Link - Install
1.
Install the stabilizer link (A).
NOTE:
The stabilizer link has a paint mark (B). The paint mark indicates the difference between the left and right stabilizer links.
Install the end of the stabilizer link with the paint mark in the upper position.
2.
Install the new self-locking nut (C) and the new flange nut (D), and tighten them to the specified torque while holding the respective joint pin (E) with a hex wrench (F).
