For some models: Disconnect the seat heater switch connector (C).
2.
Rear Door Panel - Remove
1.
Push on the upper hook (A) with the appropriate trim tool, then pull back the inner handle cap (B) to remove it.
2.
Remove the screws (A) securing the rear door inner handle.
3.
Remove the screw (A).
4.
Start at the bottom edge of the rear door panel (A), remove the clips (B) with a commercially available trim pad remover.
5.
Starting at the rear, pull the door panel upward.
NOTE: The inner handle cable (C) and the latch cable (D) are connected to the rear door inner handle (E). Do not pull up the door panel too far, or these cables will be damaged.
6.
While holding the door panel away from the door, remove the rear door inner handle (A) from the door panel by releasing the clips (B).
7.
With courtesy light: While holding the rear door panel (A) away from the door, remove the harness clip (B) and disconnect the courtesy light connector (C).
3.
Rear Door Inner Handle - Remove
Disconnect the inner handle cable (A) and the latch cable (B) from the rear door inner handle (C), then remove the handle.
4.
Rear Door Armrest - Remove
Remove the rear door armrest (A).
5.
Rear Door Inner Weatherstrip - Remove
Remove the rear door inner weatherstrip (A).
1.
Rear Door Inner Weatherstrip - Install
Install the rear door inner weatherstrip (A).
2.
Rear Door Armrest - Install
Install the rear door armrest (A).
3.
Rear Door Inner Handle - Install
Connect the inner handle cable (A) and the latch cable (B) to the rear door inner handle (C).
4.
Rear Door Panel - Install
1.
With courtesy light: While holding the rear door panel (A) away from the door, install the harness clip (B) and connect the courtesy light connector (C).
2.
While holding the door panel away from the door, install the rear door inner handle (A).
3.
Install the rear door panel (A).
NOTE: The inner handle cable (B) and the latch cable (C) are connected to the rear door inner handle (D). Do not pull up the door panel too far, or these cables will be damaged.
4.
Install the screw (A).
5.
Install the screws (A) securing the rear door inner handle.
6.
Install the inner handle cap (A).
5.
Power Window Switch Panel - Install
1.
Connect the power window switch connector (A).
2.
For some models: Connect the seat heater switch connector (B).
