Mode Control Motor Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: Set the VENT position before removing the mode control motor.

1. Glove Box - Remove

Remove the glove box.

2. Mode Control Motor - Remove
1.
Disconnect the mode control motor connector (A).
2.
Remove the mode control motor (B).


SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Mode Control Motor - Install
1.
Make sure the mode door and linkage move smoothly.
2.
Install the mode control motor (A).
3.
Connect the mode control motor connector (B).
4.
After installation, make sure the motor runs smoothly.

2. Glove Box - Install

Install the glove box.