12 Volt Battery Sensor Removal and Installation
1.
Battery Sensor - Remove
1.
Make sure the ignition switch is in LOCK (0), or the vehicle ignition in the OFF mode.
2.
Disconnect the battery sensor connector.
3.
Remove the battery sensor (A) from the battery.
4.
Disconnect the negative terminal (B) from the battery sensor.
NOTE: To protect the battery sensor connector (C) from damage, do not hold it when removing the negative terminal.
1.
Battery Sensor - Install
1.
Install the negative terminal (A) on the battery sensor (B).
NOTE:
Make sure the areas between the negative terminal and the battery sensor are clean.
To protect the battery sensor connector (C) from damage, do not hold it when installing the negative terminal.
2.
Install the battery sensor to the battery.
3.
Connect the battery sensor connector.
4.
Apply multipurpose grease to the terminal to prevent corrosion.
