Combination Light Switch Removal, Installation, and Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Column Cover - Remove

Remove the column covers.

2. Combination Light Switch - Remove
1.
Disconnect the combination light switch connector.
2.
Remove the combination light switch (A) by pressing the tabs.

1. Combination Light Switch - Test
1.
Inspect the connector terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals are OK, go to step 2.
2.
Check for continuity between the terminals in each switch position according to the tables.
3.
If the continuity is not as specified, replace the combination light switch.


SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Combination Light Switch - Install
1.
Install the combination light switch (A).
2.
Connect the combination light switch connector.

2. Column Cover - Install

Install the column covers.