Ignition Switch Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Battery Terminal - Disconnect

Do the battery terminal disconnection procedure.

2. Column Cover - Remove

Remove the column covers.

3. Ignition Switch - Test
1.
Disconnect the ignition switch connector.
2.
Check for continuity between the terminals in each switch position according to the table.
3.
If the continuity is not as specified, replace the ignition switch (A).
4.
Connect the ignition switch connector.

4. Column Cover - Install

Install the column covers.

5. Battery Terminal - Connect

Do the battery terminal reconnection procedure.