Immobilizer Control Unit Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Column Cover - Remove

Remove the column covers.

2. Immobilizer-Keyless Control Unit - Remove
1.
Disconnect the immobilizer-keyless control unit connector.
2.
Remove the immobilizer-keyless control unit (A).


SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: If the immobilizer-keyless control unit is replaced, do the immobilizer-keyless control unit registration. If the original immobilizer-keyless control unit is installed, confirm that all systems work properly.

1. Immobilizer-Keyless Control Unit - Install
1.
Install the immobilizer-keyless control unit (A).
2.
Connect the immobilizer-keyless control unit connector.

2. Column Cover - Install

Install the column covers.

3. Immobilizer-Keyless Control Unit - Register

After replacement, register the immobilizer-keyless control unit.