NOTE: With moonroof, the ambient light is built into the moonroof switch.
Remove the ambient light (A) from the front individual map light (B).
1.
Ambient Light - Test
Without Moonroof
Without Moonroof
1.
Check the ambient light by connecting battery power to terminal No. 7 and ground to terminal No. 6. The ambient light should come on.
NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
2.
If the ambient light does not come on, the LED is faulty; replace the ambient light.
With Moonroof
With Moonroof
NOTE: The ambient light (A) is built into the moonroof switch (B).
1.
Check the ambient light by connecting battery power to terminal No. 4 and ground to terminal No. 6. The ambient light should come on.
NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
2.
If the ambient light does not come on, the LED is faulty; replace the moonroof switch assembly.
1.
Ambient Light - Install
Without Moonroof
With Moonroof
NOTE: With moonroof, the ambient light is built into the moonroof switch.
Install the ambient light (A) to the front individual map light (B).
