Carefully pry off the trunk light (A) to the side to release the hook and pull out the light.
2.
Disconnect the trunk light connector.
3.
Remove the bulb (B) from the trunk light.
1.
Trunk Light - Test
NOTE: When doing the trunk light test, make sure to install the bulb correctly.
1.
Check for continuity between the terminals No. 2 (?) and No. 1 (?) according to the table.
NOTE:
Make sure the correct test lead (?or ?) is placed on the terminal.
When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
2.
If the continuity is not as specified, replace the bulb or the trunk light (A).
