Engine Start/Stop Switch Test
1. Dashboard Center Lower Cover - Remove

Remove the dashboard center lower cover.

2. Engine Start/Stop Switch - Test
1.
Disconnect the engine start/stop switch connector.
2.
Check the engine start/stop switch (A) according to the table.
NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
3.
If the result is not as specified, replace the engine start/stop switch.

3. Dashboard Center Lower Cover - Install

Install the dashboard center lower cover.