Wiper/Washer Switch Removal, Installation, and Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Column Cover - Remove

Remove the column covers.

2. Wiper/Washer Switch - Remove
1.
Disconnect the wiper/washer switch connector.
2.
Remove the wiper/washer switch (A) by pressing the tabs.

1. Wiper/Washer Switch - Test
1.
Inspect the connector terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals are OK, go to step 2.
2.
Check for continuity between the terminals in each switch position according to the table.
3.
If the continuity is not as specified, replace the wiper/washer switch (A).


SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Wiper/Washer Switch - Install
1.
Install the wiper/washer switch (A).
2.
Connect the wiper/washer switch connector.

2. Column Cover - Install

Install the column covers.