Resetting the moonroof is required when any of the following have occurred:
The moonroof stops on the way during AUTO/MANUAL operation.
The moonroof does not work during auto operation.
The moonroof was moved manually while the battery was dead or disconnected.
The moonroof motor was removed or replaced with a new one.
Any of following components related to the moonroof were replaced or removed and installed:
?
Wind deflector
?
Moonroof glass
?
Moonroof seal
?
Moonroof glass bracket
?
Moonroof frame/Drain channel slider and cable assembly
?
Moonroof cables, etc.
To reset the moonroof control unit, do these steps:
1.
Close the driver's door, and leave it closed until the procedure is complete.
2.
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
3.
Press and hold the tilt switch, and turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
4.
Release the tilt switch, and turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
5.
Repeat steps 3 and 4 four more times.
6.
Check if the AUTO OPEN and AUTO CLOSE function still work. If they still work, the AUTO functions have not been cleared, go back to step 1. If the AUTO functions have been cleared, go to step 7.
7.
Press and hold the moonroof close switch until the moonroof is tilted fully open.
8.
Confirm that the moonroof control unit is reset by using the moonroof AUTO OPEN and AUTO CLOSE function.
