ATF Hose Removal and Installation
1.
ATF Hose - Remove
Disconnect the ATF hose as needed.
NOTE: When installing the hose clamps, make sure they do not interfere with the surrounding parts.
1.
ATF Hose - Install
Connect the ATF hoses over the ATF lines with the clamps at the appropriate points in reference to the following list.
Point
Distance from hose end to clamp (L)
Hose end contact point
A
6?8 mm (0.24?0.31 in)
Bulge
B
C
D
E
F
G
6?8 mm (0.24?0.31 in)
ATF filter housing
H
2?4 mm (0.08?0.16 in)
Bulge
I
Align the yellow paint mark (J) on the ATF hose end with the paint mark (K) on the ATF warmer.
Align the blue paint mark (M) on the ATF hose end with the paint mark (N) on the ATF warmer.
2.
ATF - Level Check
Check the ATF level
.
