Torque Converter Housing Mainshaft Bearing and Oil Seal Replacement
Special Tools Required
Image
Description/Tool Number
Adjustable Bearing Puller, 25?40 mm 07736-A01000B*
Bearing Driver Attachment, 62 x 68 mm 07746-0010500
Bearing Driver Attachment, 72 x 75 mm 07746-0010600
Driver Handle, 15 x 135L 07749-0010000
*: 07736-A01000B must be used with commercially available 3/8"-16 slide hammer.
1.
Oil Seal - Remove
Remove the oil seal (A).
2.
Mainshaft Bearing - Remove
Remove the mainshaft bearing (A) using the 25?40 mm adjustable bearing puller and a commercially available 3/8"-16 slide hammer (B).
3.
Mainshaft Bearing - Install
Install the bearing until it bottoms using the 15 x 135L driver handle and the 62 x 68 mm bearing driver attachment.
4.
Oil Seal - Install
Install the oil seal flush with the torque converter housing using the 15 x 135L driver handle and the 72 x 75 mm bearing driver attachment.
NOTE: Do not drive the oil seal into the torque converter housing until it bottoms out, it will block the fluid return passage and cause transmission damage.
