To remove the mainshaft bearing (A), expand the snap ring using the snap ring pliers.
2.
Push the mainshaft bearing out using the 15 x 135L driver handle and the 80 mm I.D. seal driver attachment.
NOTE: Do not remove the snap ring unless it is necessary to clean the groove in the transmission housing.
3.
Mainshaft Bearing - Install
1.
Install the mainshaft bearing (A) in the direction shown.
2.
Expand the snap ring using the snap ring pliers.
3.
Insert the mainshaft bearing part-way using the 15 x 135L driver handle and the 80 mm I.D. seal driver attachment.
4.
Release the snap ring pliers.
5.
Push the mainshaft bearing down until the snap ring snaps in place around it.
6.
After installing the bearing, check that the snap ring (A) is seated in the bearing and the housing groove, and that the snap ring end gap (B) is 0?7 mm (0?0.28 in).
