Front Passenger's Airbag Cutoff Indicator Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Battery Terminal - Disconnect

Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Multi-Information Display Unit - Remove

Remove the multi-information display unit.

3. Front Passenger's Airbag Cutoff Indicator - Remove
Remove the front passenger's airbag cutoff indicator (A).



SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Front Passenger's Airbag Cutoff Indicator - Install
Install the front passenger's airbag cutoff indicator (A).


2. Multi-Information Display Unit - Install

Install the multi-information display unit.

3. Battery Terminal - Connect

Do the battery terminal reconnection procedure.

4. DTC - Clear

Clear any DTCs with the HDS.

5. SRS Operation - Confirm

Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.