Rear Safing Sensor Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1.	Battery Terminal - Disconnect

Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2.	Rear Seat Cushion - Remove

Remove the rear seat cushion.

3.	Rear Safing Sensor - Remove

Disconnect the rear safing sensor connector (A) on the right side wire harness.

Remove the TORX bolt (B) using a TORX T30 bit, then remove the rear safing sensor (C).

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1.	Rear Safing Sensor - Install

Install the rear safing sensor (A) with the new TORX bolt (B), using a TORX T30 bit.

Connect the rear safing sensor connector (C) on the right side wire harness.

2.	Battery Terminal - Connect

Do the battery terminal reconnection procedure.

3.	DTC - Clear

Clear any DTCs with the HDS.

4.	SRS Operation - Confirm

Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

5.	Rear Seat Cushion - Install

Install the rear seat cushion.