Disconnect the reverse lockout solenoid connector (A).
2.
Remove the reverse lockout solenoid (B).
NOTE: Do not directly hit the reverse lockout solenoid with the hammer.
3.
Reverse Lockout Solenoid - Disassemble
Remove the pin (A), the select lock return spring (C), and select lock cam B.
1.
Reverse Lockout Solenoid - Reassemble
Install the pin (A), the select lock return spring (C), and select lock cam B.
2.
Reverse Lockout Solenoid - Install
1.
Clean any dirt and oil from the sealing surface of the reverse lockout solenoid and the shift arm cover.
2.
Apply liquid gasket (P/N 08718-0004 or 08718-0009) evenly to the shift arm cover mating surface of the reverse lockout solenoid. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
3.
Install the reverse lockout solenoid (A).
4.
Connect the reverse lockout solenoid connector (B).
