Remover Installer, 22 x 37/46 x 52 mm 07PAF-0030100
1.
Differential Carrier Bearing - Remove
Clutch housing side
Transmission housing side
1.
Check the carrier bearings for wear and rough rotation. If they rotate smoothly and their rollers show no signs of wear, the bearings are OK.
2.
Remove the carrier bearings (A) with a commercially available bearing puller (B).
2.
Differential Carrier Bearing - Install
Clutch housing side
Transmission housing side
Install the carrier bearings (A) using the 22 x 37/46 x 52 mm remover installer, an attachment and, a press. Press on each bearing until it bottoms. There should be no clearance between the bearings and the differential carrier.
NOTE: Place the seal part (B) of the bearing towards the outside of the differential, then install it.
