Install the driveshaft and the intermediate shaft into the differential assembly.
2.
Carefully clamp the driveshaft (A) in a bench vise (B).
3.
Place the intermediate shaft (C) on a V-block (D), then fix the intermediate shaft using vise grips or equivalent (E).
4.
Measure the backlash of the final driven gear (F) with a dial indicator (G). If the backlash is not within the standard, check the differential carrier and replace it if necessary.
NOTE: If it needs to replace the differential carrier, the final driven gear as a set. Do not remove the final driven gear from the differential carrier.
