Remove the bearing outer race, the spacer, and the 81 mm shim from the transmission housing by heating the housing to about 212 °F (100 °C) with a heat gun.
NOTE: Do not reuse the 81 mm shim if the outer race was driven out.
2.
Remove the bearing outer race and the spacer from the clutch housing by heating the housing to about 212 °F (100 °C) with a heat gun.
4.
Differential Carrier Bearing Outer Race - Install
1.
Install the 81 mm shim (A), the spacer (B), and the bearing outer race (C) into the transmission housing (D) using the 15 x 135L driver handle and the 78 x 80 mm bearing driver attachment.
2.
Install the spacer (A) and the bearing outer race (B) into the clutch housing (C) using the 15 x 135L driver handle and the 78 x 80 mm bearing driver attachment.
