PCM Reset
1.
HDS DLC - Connect
1.
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2.
Press the engine start/stop button to select the ON mode.
3.
Make sure the HDS communicates with the vehicle. If it does not communicate,
go to the DLC circuit troubleshooting
.
2.
PCM - Reset
1.
Select the A/T system with the HDS.
2.
Reset the PCM with the HDS while the engine is stopped.
3.
Press the engine start/stop button to select the OFF mode.
4.
Press the engine start/stop button to select the ON mode.
5.
Wait for 30 seconds.
6.
Press the engine start/stop button to select the OFF mode.
7.
Disconnect the HDS from the DLC.
Fuel and Emissions Systems Learning Procedure
3.
Fuel and Emissions Systems - Learn
Do the fuel and emissions systems learning procedure
.
