SRS components are located in this area. Review the SRS component locations, 2-door, 4-door and the precautions and procedures before doing repairs or service.
Disconnect the combination light switch connector (A).
2.
Remove the combination light switch (B) by pressing the tabs.
1.
LaneWatch Switch - Test
1.
On the switch side, check for continuity between the combination light switch 12P connector terminals in each switch position according to the table.
2.
If the continuity is not as specified, replace the combination light switch.
SRS components are located in this area. Review the SRS component locations, 2-door, 4-door and the precautions and procedures before doing repairs or service.
1.
Combination Light Switch - Install
1.
Install the combination light switch (A).
2.
Connect the combination light switch connector (B).
