PCM Reset
1. HDS DLC - Connect
1.
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
3.
Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

2. PCM - Reset
1.
Select the A/T SYSTEM with the HDS.
2.
Reset the PCM with the HDS while the engine is stopped.
3.
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
4.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
5.
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, and disconnect the HDS from the DLC.

Fuel and Emissions Systems Learning Procedure

3. Fuel and Emissions Systems - Learn