CVT Driven Pulley Pressure Sensor Removal and Installation
NOTE: Keep all foreign particles out of the transmission.
1.
Vehicle - Lift
Raise and support the vehicle
.
2.
Engine Undercover - Remove
Remove the engine undercover
.
3.
CVT Driven Pulley Pressure Sensor - Remove
1.
Disconnect the CVT driven pulley pressure sensor connector (A).
2.
Remove the CVT driven pulley pressure sensor (A) with the sealing washer (B).
NOTE: Loosen the CVT driven pulley pressure sensor by gripping the metal part, not the plastic part.
NOTE: Keep all foreign particles out of the transmission.
1.
CVT Driven Pulley Pressure Sensor - Install
1.
Install the CVT driven pulley pressure sensor (A) using a new sealing washer (B).
NOTE: Tighten the CVT driven pulley pressure sensor by gripping the metal part, not the plastic part.
2.
Connect the CVT driven pulley pressure sensor connector (A).
NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.
2.
Engine Undercover - Install
Install the engine undercover
.
