CVTF Warmer Hose Removal and Installation
1. Vehicle - Lift

Raise and support the vehicle.

2. Engine Coolant - Drain

Drain the engine coolant.

3. Splash Separator - Remove

Remove the splash separator.

4. Front Bumper Upper Air Duct - Remove

Remove the front bumper upper air duct.

5. Battery - Remove

Do the battery removal procedure.

6. Air Cleaner - Remove

Remove the air cleaner.

7. PCM with Bracket - Remove
1.
Disconnect PCM connectors A, B, and C.
NOTE: PCM connectors A, B, and C have symbols (A=?, B=?, C=?) embossed on them for identification.
2.
Remove the harness clamps (D).
3.
Remove the harness holder (E).
4.
Remove the PCM (F) with the bracket.

8. Battery Base - Remove
1.
Remove the harness clamps (A).
2.
Remove the battery base (B).
NOTE: Loosen the bolts (C), without removing them.

9. Transmission Fluid Warmer Hose - Disconnect
NOTE: To prevent damage, cover the solenoid wire harness A connector using a shop towel.

Disconnect the transmission fluid warmer inlet hose (A) and outlet hose (B).

NOTE: Check the transmission fluid warmer for wear and damage, when disconnecting the transmission fluid warmer hose.



NOTE: When installing the hose clips, make sure they do not interfere with the surrounding parts.

1. Transmission Fluid Warmer Hose - Connect
1.
Connect the transmission fluid warmer inlet hose (A) and outlet hose (B) until each bulge (C) of the transmission fluid warmer line.
NOTE: Check the transmission fluid warmer for wear and damage, when connect the transmission fluid warmer hose.
2.
Align the black paint marks (A) on the transmission fluid warmer lines with the white paint marks (B) on the transmission fluid warmer hose ends.
3.
Secure the transmission fluid warmer hoses with the clamps (C).
4.
Clamp the transmission fluid warmer outlet hose (A) with the hose clamp (B) at the white paint line (C).
5.
Clean up any spilled engine coolant.

2. Battery Base - Install
1.
Install the battery base (A).
2.
Install the harness clamps (B).

3. PCM with Bracket - Install
1.
Install the PCM (D) with the bracket.
2.
Install the harness holder (E).
3.
Connect PCM connectors A, B, and C.
NOTE: PCM connectors A, B, and C have symbols (A=?, B=?, C=?) embossed on them for identification.
4.
Install the harness clamps (F).

4. Air Cleaner - Install

Install the air cleaner.

6. Front Bumper Upper Air Duct - Install

Install the front bumper upper air duct.

7. Splash Separator - Install

Install the splash separator.

9. Transmission Fluid Level - Check

Check the transmission fluid level.