Transmission Housing Driven Pulley Shaft Bearing Replacement
Special Tools Required
Image Description/Tool Number
310230.png Snap Ring Pliers 07LGC-0010100
310166.png Driver Handle, 40 mm I.D. 07746-0030100
310167.png Bearing Driver Attachment, 30 mm I.D. 07746-0030300
1. Driven Pulley Shaft Bearing - Remove
1.
Remove the snap ring (A) using the snap ring pliers.
2.
Remove the cotter retainer (A).
3.
Remove the 25.5 mm cotters (B).
4.
Remove the driven pulley shaft bearing (A) using a commercially available puller (B) and a spacer (C).

1. Driven Pulley Shaft Bearing - Install
1.
Drive the driven pulley shaft bearing (A) securely using the 40 mm I.D. driver handle and the 30 mm I.D. bearing driver attachment so there is no clearance between the driven pulley shaft bearing and the secondary drive gear.
2.
Clean the cotter groove of the driven pulley shaft.
3.
Install the 25.5 mm cotters (A).
5.
Install the cotter retainer (B).
6.
Install the snap ring (A) using the snap ring pliers.
7.
Check that the snap ring is seated in the snap ring groove of the driven pulley shaft.
8.
Measure the snap ring outside diameter and end gap.

Dimensions After Setting Snap Ring
End Gap (A):
7.2 mm (0.283 in) or less
Outside Diameter (B):
33.9 mm (1.335 in) or less