Audio Unit Removal and Installation

NOTE:
When working on electronic components, make sure the work area is clean and dust free.
Take care not to scratch the touch panel.
Eject the disc before disconnecting the audio unit to prevent damaging the CD player load mechanism.
If you are replacing the audio unit, write down the audio presets (if possible), and enter them into the new audio unit.

4. Audio Unit Assembly - Remove
1.
Remove the bolts (A).
2.
Pull out the audio unit assembly (A).
3.
Disconnect the hazard warning switch connector (B) and the audio-navigation unit connectors.

5. Audio Unit - Remove
NOTE:
Do not touch the circuit board(s) with your bare hands.
Discharge static electricity from your body before and during the work.
Do not touch the terminal connector of the flat plate cable with your bare hands (If you have touched it, wipe it off thoroughly).
1.
Remove the holder (A).
2.
Disconnect the connector (A), and remove the audio unit (B) from the audio panel (C).

6. All Removed Parts - Install
1.
Install the audio unit in the reverse order of removal.
NOTE: After Installation, do the System Links in the System Diagnostic Mode to confirm that there are no problems in the system.