Millimeter Wave Radar Mounting Position Inspection

NOTE:
Make sure the steering wheel is pointed straight ahead, and do not turn it after setting up the vehicle.
When the millimeter wave radar is adjusted on a ground that has more than one degree of horizontal slope (drainage slope), the vertical aiming cannot be adjusted correctly. Check the levelness of the ground, but if there is a continuous slope, then adjust the angle of millimeter wave radar so it is parallel to the ground. Lay a ruler or other flat straight object on the ground and put the level on top to confirm the levelness of the ground.

2. Millimeter Wave Radar - Inspection
1.
Put a level (A) on the millimeter wave radar.
NOTE: Use the level included in the alignment set.
2.
Turn the vertical adjusting bolt (B) with a screwdriver, and adjust the angle of millimeter wave radar so that the air bubble in the level is centered.
NOTE:
If you cannot adjust the millimeter wave radar horizontally, check for damage on the millimeter wave radar bracket or the vehicle frame.