MIL Circuit Troubleshooting
MIL Circuit Troubleshooting
1.
Gauge control module check:

Gauge control module check
?1.
Press the engine start/stop button to select the ON mode.

?2.
Do the gauge self-diagnostic function.

Does the MIL flash?

     
YES
     
     
     
Go to step 2.
     
NO
     
     
     
Substitute a known-good gauge control module, then recheck. If the symptom/indication goes away with a known-good gauge control module, replace the original gauge control module.?
2.
PCM check:

PCM check
?1.
Press the engine start/stop button to select the OFF mode.

?2.
Connect the HDS to the DLC.

?3.
Press the engine start/stop button to select the ON mode.

?4.
Check the parameter(s) below with the HDS.
Signal
Threshold
Current conditions
Values
Unit
Values
Unit
SCS
Short
      

Do the current condition(s) match the threshold?

     
YES
     
     
     
Go to step 3.
     
NO
     
     
     
Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away and the PCM was updated, troubleshooting is complete. If the symptom/indication goes away and the PCM was substituted, replace the original PCM.?
3.
Shorted wire check (SCS line):

Shorted wire check (SCS line)
?1.
Press the engine start/stop button to select the OFF mode.

?2.
Jump the SCS line with the HDS.


?3.
Disconnect the following connector.

?4.
Disconnect the HDS.

?5.
Check for continuity between test points 1 and 2.
Test condition
OFF mode
 
PCM connector A (51P): disconnected
Test circuit
SCS
Test point 1
PCM connector A (51P) No. 39 (PNK)
Test point 2
Body ground


Is there continuity?

     
YES
     
     
     
Repair a short in the SCS wire between the PCM (A39) and the DLC.?
     
NO
     
     
     
The SCS wire is OK. Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away and the PCM was updated, troubleshooting is complete. If the symptom/indication goes away and the PCM was substituted, replace the original PCM.?