DTC Troubleshooting: P1683 (V6) - Honda Accord CR/CT 2012-2017

DTC Troubleshooting: P1683

DTC P1683: Throttle Valve Default Position Spring Performance Problem

Do not insert your fingers into the installed throttle body when you press the engine start/stop button to select the ON mode, or while the vehicle is in the ON mode. If you do, you will seriously injure your fingers if the throttle valve is activated.

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.

DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
P1683 Throttle Valve Default Position Spring Performance Problem

Problem verification:

Problem verification

?1.	Press the engine start/stop button to select the ON mode.

?2.	Clear the DTC with the HDS.

?3.	Start the engine. Hold the engine speed at 3,000 rpm without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.

?4.	Press the engine start/stop button to select the OFF mode, and wait for 10 seconds.

?5.	Press the engine start/stop button to select the ON mode.

?6.

Check for Pending or Confirmed DTCs with the HDS.

DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
P1683 Throttle Valve Default Position Spring Performance Problem

Is DTC P1683 indicated?


	YES

The failure is duplicated. Go to step 2.


	NO

Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the throttle body and the PCM.?

Throttle body default position spring check:

Throttle body default position spring check

?1.	Press the engine start/stop button to select the OFF mode.

?2.	Disconnect the intake air duct from the throttle body.

?3.	Push the throttle valve closed as shown.

?4.	Release the throttle valve.

Does the throttle valve return?


	YES

Clean the throttle body, then do the repair verification. If DTC P1683 is indicated, replace the throttle body, then do the repair verification.


	NO

Replace the throttle body, then do the repair verification.

Repair verification:

?1.	Press the engine start/stop button to select the ON mode.

?2.	Reset the PCM with the HDS.

?3.	Do the PCM idle learn procedure.

?4.	Press the engine start/stop button to select the OFF mode, and wait for 10 seconds.

?5.	Press the engine start/stop button to select the ON mode.

?6.

Check for Pending or Confirmed DTCs with the HDS.

DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
P1683 Throttle Valve Default Position Spring Performance Problem

Is DTC P1683 indicated?


	YES

Check for poor connections or loose terminals at the throttle body and the PCM, then go to step 1.


	NO

Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.?