P0746 CVT Drive Pulley Pressure Control Solenoid Valve Stuck OFF
1.
DTC check:
DTC check
?1.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
?2.
Clear the DTC with the HDS.
?3.
Start the engine.
?4.
Test-drive the vehicle in D until the vehicle speed reaches 37 mph (60 km/h). Slow down and stop the vehicle, then accelerate from a stop at full throttle in D until the vehicle speed reaches 37 mph (60 km/h).
?5.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P0746 CVT Drive Pulley Pressure Control Solenoid Valve Stuck OFF
Intermittent failure, the system is OK at this time.?
Repair verification (OBD STATUS check):
?1.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
?2.
Clear the DTC with the HDS.
?3.
Start the engine.
?4.
Test-drive the vehicle in D until the vehicle speed reaches 37 mph (60 km/h). Slow down and stop the vehicle, then accelerate from a stop at full throttle in D until the vehicle speed reaches 37 mph (60 km/h).
?5.
Monitor the OBD STATUS for P0746 in the DTCs MENU with the HDS.
DTC Description
OBD Status
P0746 CVT Drive Pulley Pressure Control Solenoid Valve Stuck OFF
Does the HDS indicate PASSED, FAILED, or NOT COMPLETED?
PASSED
Troubleshooting is complete. Check for other DTC after this troubleshooting. If any other Pending or Confirmed DTCs were indicated, go to the indicated DTC's troubleshooting.?
FAILED
Troubleshooting is incomplete, then go to step 1 and recheck.
NOT COMPLETED
Repair verification is incomplete. Meet the test condition, and check the OBD STATUS again.