|
DTC Troubleshooting: B1125
DTC B1125: Driver's Power Window Motor A Pulse Malfunction
|
DTC Description |
DTC |
|
B1125 Driver's power window motor A pulse malfunction |
| |
|
|
1. |
Problem verification:
Problem verification
|
?1. |
Check the parameter(s) below with the HDS.
|
Signal |
Current conditions |
|
Values |
Unit |
|
Driver's P/W Motor Pulse A |
|
| |
| | |
Does the information indicator display DETECT while the window is moving, and display NONE when the window is stopped?
|
|
|
Intermittent failure, the system is OK at this time.? |
|
|
|
|
|
2. |
Power window motor pulse check:
Power window motor pulse check
|
?1. |
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode. |
|
?2. |
Disconnect the following connector.
|
|
?3. |
Connect terminals A and B with a jumper wire.
|
Terminal A |
Driver's power window motor 6P connector No. 5 (ORN) |
|
Terminal B |
Body ground | |
|
|
|
?4. |
Connect and disconnect the jumper wire to body ground repeatedly. |
|
?5. |
Check the parameter(s) below with the HDS.
|
Signal |
Current conditions |
|
Values |
Unit |
|
Driver's P/W Motor PulseA |
|
| |
| | |
Does the information indicator display DETECT?
|
3. |
Shorted wire check (P/W DR MTR PLSA line):
Shorted wire check (P/W DR MTR PLSA line)
|
?1. |
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode. |
|
?2. |
Disconnect the jumper wire. |
|
?3. |
Disconnect the following connector.
|
|
?4. |
Check for continuity between test points 1 and 2 individually.
|
Test condition |
IG LOCK (0) or OFF mode
Driver's power window motor 6P connector: disconnected
Power window master switch 37P connector: disconnected |
|
Test circuit |
P/W DR MTR PLSA |
|
Test point 1 |
Power window master switch 37P connector No. 17 (ORN) |
|
Test point 2 |
Body ground | |
|
| |
Is there continuity?
|
|
|
Repair a short to ground in the wire.? |
|
|
|
Repair an open or high resistance in the wire.? | |