Before reprogramming the gauge control module, make sure the battery in the vehicle is fully charged, and connect a jumper battery (not a battery charger) to maintain system voltage.
Never turn the ignition switch to ACC (I) or LOCK (0) or press the engine start/stop button to select the ACC or OFF mode, during the reprogramming. If there is a problem with the reprogramming, turn the ignition switch to ON (II) or press the engine start/stop button to select the ON mode.
1.
Problem verification:
Problem verification
?1.
Clear the DTCs with the HDS.
?2.
Turn the ignition switch to LOCK (0) and then back to ON (II), or press the engine start/stop button to select the OFF mode and then the ON mode.
?3.
Check for DTCs with the HDS.
DTC Description
DTC
U3000-51 Reprogramming Error
Is DTC U3000-51 indicated?
YES
Reprogramming the gauge control module.?
NO
Intermittent failure, the system is OK at this time.?
