DTC Advanced Diagnostics: P0351, P0352, P0353, P0354 (L15B7/L15BA/L15BY)

DTC Advanced Diagnostics: P0351, P0352, P0353, P0354

DTC P0351:No. 1 Cylinder Ignition Coil Circuit Malfunction
DTC P0352:No. 2 Cylinder Ignition Coil Circuit Malfunction
DTC P0353:No. 3 Cylinder Ignition Coil Circuit Malfunction
DTC P0354:No. 4 Cylinder Ignition Coil Circuit Malfunction

General Description

The ignition coil is triggered at the optimum time by the powertrain control module (PCM) ON/OFF command. The PCM detects a malfunction when the engine is running and the return signal does not change for a specified time, the PCM detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type

Execution	Continuous
Sequence	None
Duration	5 seconds or more (when the engine speed is 700 rpm)
DTC Type	One drive cycle, MIL on

Enable Conditions

Condition
State of the engine	Running

Malfunction Threshold

The return signal does not change for at least 5 seconds when the ignition coil is triggered.

Possible Cause

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.

DTC: P0351

	No. 1 ignition coil IGN01 line open
	No. 1 ignition coil IGN01 line short to ground

DTC: P0352

	No. 2 ignition coil IGN02 line open
	No. 2 ignition coil IGN02 line short to ground

DTC: P0353

	No. 3 ignition coil IGN03 line open
	No. 3 ignition coil IGN03 line short to ground

DTC: P0354

	No. 4 ignition coil IGN04 line open
	No. 4 ignition coil IGN04 line short to ground

Common

	Ignition coil power supply line open
	Ignition coil ground line open
	Ignition coil internal circuit failure
	PCM internal circuit failure

Diagnosis Details

Conditions for setting the DTC

When a malfunction is detected, the MIL comes on and a Pending DTC, a Confirmed DTC, and the freeze data are stored in the PCM memory.

Conditions for clearing the DTC

The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the 12 volt battery.