DTC Advanced Diagnostics: P0369
DTC P0369:Camshaft Position (CMP) Sensor B Circuit Intermittent Interruption

General Description

Camshaft position (CMP) sensor B consists of a rotor and a semiconductor that detects rotor position. When the rotor turns after starting the engine, the changes of magnetic flux in the semiconductor are converted into pulsing signals to the powertrain control module (PCM). The PCM determines exhaust camshaft timing position according to the pulsing signals from CMP sensor B and the crankshaft position (CKP) sensor. If abnormal amount of pulsing signals from CMP sensor B are detected, the PCM detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type
Execution
Continuous
Sequence
None
Duration
–
DTC Type
One drive cycle, MIL on

Enable Conditions
Condition
Minimum
Maximum
Engine speed
[ENGINE SPEED]
400 rpm
-
[ ]: HDS Parameter

Malfunction Threshold
The PCM detects abnormal pulsing signals from CMP sensor B at least 60 times.

Possible Cause
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
CMP sensor B CAM EX line electrical noise overlapped
CMP sensor B rotor chipped
CMP sensor B failure
PCM internal circuit failure

Diagnosis Details
Conditions for setting the DTC
When a malfunction is detected, the MIL comes on and a Pending DTC, a Confirmed DTC, and the freeze data are stored in the PCM memory.

Conditions for clearing the DTC
The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the 12 volt battery.