DTC Advanced Diagnostics: P16E2
DTC P16E2:PGM-FI-ACG LIN Communication Error

General Description

The local interconnect network (LIN) line connects the alternator and the powertrain control module (PCM). The LIN uses a master/slave protocol to send and receive data to the different components on the line. The PCM is the master unit, which controls the engine electrical system. The 12 volt battery sensor and the alternator are the slaves. The alternator receives data from the PCM and provides feedback to the PCM, which allows the PCM to operate the engine electrical system efficiently. When the PCM does not receive signals from the alternator within its specified amount of time, the PCM detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type
Execution
Continuous
Sequence
None
Duration
5 seconds or more
DTC Type
One drive cycle, MIL off

Enable Conditions
Condition
Minimum
Maximum
Elapsed time after the vehicle condition is turned to the ON mode
3 seconds
–
12 volt battery voltage [BATTERY]
10.0 V
–
[ ]: HDS Parameter

Malfunction Threshold
Either one of the conditions is met for at least 5 seconds:
The PCM cannot receive any information via the LIN line.
The information sent from the alternator is abnormal.

Possible Cause
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
Alternator failure
Alternator LIN(BATT SENSOR) line open
Alternator LIN(BATT SENSOR) line short
PCM internal circuit failure

Diagnosis Details
Conditions for setting the DTC
When a malfunction is detected, a Pending DTC, a Confirmed DTC, and the freeze data are stored in the PCM memory. The MIL does not come on.

Conditions for clearing the DTC
The Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the 12 volt battery.