DTC Advanced Diagnostics: P062B
DTC P062B:Powertrain Control Module (PCM) Internal Circuit Malfunction

General Description

The injector supplies fuel to the engine and its fuel pressure is adjusted by high pressure fuel pump output duty cycle, and controlled by the powertrain control module (PCM) ON/OFF command. In the PCM, the injector driver receives commands from the CPU and drives injectors and solenoids. Also, the CPU sets current to drive injectors and solenoids, and transmits the current to the injector driver. If an abnormal communication occurs in the PCM, the PCM detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type
Execution
Continuous
Sequence
None
Duration
-
DTC Type
One drive cycle, MIL on

Enable Conditions
Condition
Minimum
Maximum
12 volt battery voltage [BATTERY]
7 V
–
State of the engine
Running
[ ]: HDS Parameter

Malfunction Threshold
The CPU cannot communicate with injector driver at least 100 times (counts once per 30 ° camshaft angle).

Possible Cause
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
PCM internal circuit failure

Diagnosis Details
Conditions for setting the DTC
When a malfunction is detected, the MIL comes on and a Pending DTC, a Confirmed DTC, and the freeze data are stored in the PCM memory.

Conditions for clearing the DTC
The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command.