DTC Advanced Diagnostics: P2563 (K20C1) - Honda Civic FC/FK 2016-2021

DTC Advanced Diagnostics: P2563

DTC P2563:Turbocharger Wastegate Control Actuator Position Sensor Out of Range

General Description

The powertrain control module (PCM) monitors the turbocharger wastegate control actuator position sensor circuit for physical range check. The diagnostic compares the voltages of the turbocharger wastegate control actuator position sensor read at the closed and open positions of the turbocharger valve with their respective calibrated threshold values. If the turbocharger wastegate control actuator position sensor output voltage is a specified value for a specified time, the PCM detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type

Execution	Continuous
Sequence	None
Duration	0.14 second or more
DTC Type	Two drive cycles, MIL on

Enable Conditions

Condition
State of the engine	Running

Malfunction Threshold

Either of the conditions continues for at least 0.14 second.

	The turbocharger wastegate control actuator position sensor voltage [EWG Voltage From Lift Sensor] read at the closed position of the turbocharger valve is 0.2 - 0.35 V.
	The turbocharger wastegate control actuator position sensor voltage [EWG Voltage From Lift Sensor] read at the open position of the turbocharger valve is greater than 4.74 - 4.81 V.

[ ]: HDS Parameter

Possible Cause

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.

	Turbocharger wastegate control actuator position sensor failure
	PCM internal circuit failure

Diagnosis Details

Conditions for setting the DTC

When a malfunction is detected during the first drive cycle, a Pending DTC is stored in the PCM memory. If the malfunction returns in the next (second) drive cycle, the MIL comes on and a Confirmed DTC and the freeze data are stored.

Conditions for clearing the DTC

The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command.