|
EPS System Description - Steering Angle Detection
Overview
The EPS control unit calculates a steering angle from the motor angle sensor value. The EPS control unit detects the motor rotational angle (A) with the motor angle sensor, and calculates the assist pinion shaft angle (B) by multiplying the motor rotational angle by the reduction ratio of the worm gear. Based on the assist pinion shaft angle, initial steering angle, and VGR (Variable Gear Ratio) conversion map, it calculates the manual pinion shaft angle (C), corrects the torsional angle of the torsion bar based on the torque sensor value, and finally calculates the steering wheel angle (D). Detection Block Diagram
Steering Angle Neutral Position Learning
The EPS control unit learns the steering angle neutral position to detect an initial steering angle when ignition switch is turned to ON mode. The steering angle neutral position learning is classified into initial learning and the regular learning. Initial Learning
The initial learning is performed automatically at the time of the first driving after steering angle neutral position is cleared. When the EPS control unit judges that the vehicle is going straight based on each sensor signals, the steering angle neutral position is learned. For more details of the learning procedure, refer to Steering Angle Neutral Position Learning. The steering angle neutral position is cleared whenever you do any of these actions:
Regular Learning
The regular learning revises a gap of the neutral position that occurs due to normal wear and tear of the vehicle and a change of the wheel alignment during driving. Learning using the HDS
The VSA sensor neutral position memorization for VSA system is performed using the HDS, the steering angle neutral position is cleared and overwritten. |
