Transmission Fluid Pump Removal and Installation

NOTE:
enu_12713377_2.0 Where icon is shown, click for further information.
Keep all foreign particles out of the transmission.


1

129_3.0_enu_14144904_3.0

enu_12713377_2.0
Detailed information, notes and precautions
enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
enu_12714524_1.0
Replace

3. Engine - Warm Up
1.
Start the engine, and warm it up to normal operating temperature (the radiator fan comes on twice).
2.
Turn the engine off.

5. Transmission Fluid Pan - Remove

NOTE: The actual transmission fluid (HCF-2) capacity will vary from the specified capacity based on the length of time the transmission fluid pan is off the transmission. Avoid leaving the transmission fluid pan off for extend periods of time.

6. Magnet - Remove


7. Transmission Fluid Strainer - Remove


8. Transmission Fluid Strainer - Check
1.
Clean the inlet opening (A) of the transmission fluid strainer (B) thoroughly with compressed air.
2.
Check that it is in good condition and that the inlet opening is not clogged.
3.
Test the strainer by pouring clean transmission fluid through the inlet opening, and replace it if it is clogged or damaged.

9. Valve Body Assembly - Remove
1.
Remove the valve body assembly mounting bolts.
Bolt
Length
A
90 mm (3.54 in)
B
65 mm (2.56 in)
2.
Remove the valve body assembly (A) straightly and disconnect the connector (B).
NOTE: Be careful not to damage the solenoid wire harness.

10. 10.9 x 29 mm Pipe - Remove


11. 10.9 x 48 mm Pipe - Remove


12. 10.9 x 75.5 mm Pipe - Remove


13. 18 x 21 mm Pipe - Remove


14. Transmission Fluid Pump - Remove


15. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE:
Apply a light coat of clean transmission fluid on all O-rings before installation.
Be careful not to damage the O-rings.
Do not pinch the solenoid wire harnesses.
Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.

17. TCM - Reset (Only for Replacing Transmission Fluid Pump and/or Valve Body Assembly)

NOTE: This procedure is not required, if the TCM, and the transmission fluid pump and/or the valve body assembly are replaced simultaneously.