Turn the control lever (A) to the P position, then turn it back two clicks to the N position.
4.
Transmission Range Switch - Remove
1.
Pry down the lock tab (A) of the lock washer (B).
2.
Remove the control lever (C) and the lock washer.
3.
Disconnect the connector (D) by pulling the lock (E) and the lever (F) in the numbered sequence shown.
4.
Remove the control shaft cover (G).
5.
Remove the transmission range switch (H).
1.
Transmission Range Switch - Install
1.
Set the transmission range switch (A) to the N position. Align the cutouts (B) on the rotary-frame with the N positioning cutouts (C) on the transmission range switch, then put a 2.0 mm (0.079 in) feeler gauge (D) in the cutouts to hold the transmission range switch in the N position.
NOTE: Be sure to use a 2.0 mm (0.079 in) feeler gauge or equivalent to hold the transmission range switch in the N position.
2.
Install the transmission range switch (A) gently on the control shaft (B) while holding it in the N position with the 2.0 mm (0.079 in) feeler gauge (C).
3.
Tighten the bolts on the transmission range switch while you continue holding the N position.
4.
Remove the feeler gauge.
5.
Connect the connector (D), and make sure it is fully seated.
NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.
6.
Install the control shaft cover (E).
7.
Install the control lever (F) as shown.
8.
Secure the control lever with a new lock washer (G), then pry up the lock tab (H) of the lock washer against the bolt head.
