Final Drive Shaft Disassembly and Reassembly
Special Tools Required
Image Description/Tool Number
310169.png Driver Handle, 15 x 135L 07749-0010000
1790757.png Attachment, 45 mm 07947-6890300
310219.png Bearing Separator 07KAF-PS30200

NOTE:
enu_12713377_2.0 Where icon is shown, click for further information.
The final drive shaft bearing and the final drive shaft bearing outer race should be replaced as a set.


1


173_3.0_enu_13968094_3.0

enu_12713377_2.0
Detailed information, notes and precautions
enu_12714524_1.0
Replace

1. Final Drive Shaft Bearing - Remove
1.
Remove the final drive shaft bearings (A) using the bearing separator, a commercially available spacer (B), and a press.

2. Cotter Retainer - Remove


3. 29 mm Cotter - Remove


4. Secondary Driven Gear - Remove
1.
Remove the secondary driven gear (A) using a press.


NOTE:
enu_12713377_2.0 Where icon is shown, click for further information.
The final drive shaft bearing and the final drive shaft bearing outer race should be replaced as a set.
Adjust the final drive shaft bearing preload after replacing the final drive shaft bearing.
Apply a light coat of clean transmission fluid on all parts before installation.


1


173_3.0_enu_13968095_3.0

enu_12713377_2.0
Detailed information, notes and precautions
enu_12714524_1.0
Replace

1. Secondary Driven Gear - Install
1.
Install the secondary driven gear (A) until it bottoms in the direction shown using a press.

2. 29 mm Cotter - Install


3. Cotter Retainer - Install


4. Final Drive Shaft Bearing - Install
1.
Install the final drive shaft bearings (A) until they bottom using the 15 x 135L driver handle, the 45 mm attachment, and a press.