Automatic Lighting/Rain Sensor Removal and Installation
2. Automatic Lighting/Rain Sensor - Remove
1.
Release the lock (A).
2.
Remove the automatic lighting/rain sensor (B) from the bracket (C).
3.
Disconnect the connector (D).
4.
Remove the silicon sheet (A).
NOTE:
Do not reuse the silicon sheet.
If the silicon sheet is not on the back of the rain sensor after removal, it will remain on the glass surface. Make sure to peel it off prior to installation.

1. Silicon Sheet - Replace
NOTE:
Never touch the primed surface on the automatic lighting/rain sensor with your hands.
Do not put on the silicon sheet out of the automatic lighting/rain sensor.
Be careful not to touch the silicon sheet surfaces, make sure it is clean. Keep it away from dust.
1.
Remove the protective sheet A from the silicon sheet (C).
2.
Hold the protective sheet B, then set and put the silicon sheet on position (D) to the automatic lighting/rain sensor (E).
3.
Remove the protective sheet B.

2. Automatic Lighting/Rain Sensor - Install
NOTE:
If the automatic lighting/rain sensor connector is connected after the 12 volt battery terminal is connected, the automatic lighting/rain sensor is not confirmed by the body control module.
If the body control module does not confirm the automatic lighting/rain sensor, the automatic wiper system does not work.
Connect the automatic lighting/rain sensor connector first, then connect the 12 volt battery terminal.
1.
Connect the connector (A).
2.
Install the automatic lighting/rain sensor (B) onto the mounting bracket (C), then push in on the lock (D).